equipment:edgerouterxswitch
This is an old revision of the document!
Table of Contents
Setup EdgeRouter X as switch
This will guide you through the setup of the EdgeRouter X to be used as a switch. This currently is employed due to issues created by using a cheap switch with the unifi APs.
Connect
- Plug in using PoE injection or 12V 0.5Amp Power adapter
- Connect computer to ETH0
- Setup computer with 192.168.1.XXX address
- Connect to EdgeRouter at 192.168.1.1
- Probably need to accept any exceptions / agree to connect
- Login with “ubnt” “ubnt”
Initial Setup
- Run Wizards
- Choose Switch
- Select DHCP
- Create new admin user (or keep existing users if changing from router to switch and not factory reset)
- Apply
equipment/edgerouterxswitch.1700523824.txt.gz · Last modified: by dirk
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
